Custom Hydraulic Presses for Assembly Applications

Custom Hydraulic Presses for Assembly Applications

150 ton four column press with hydraulic slide table for bearing assembly.

Phoenix buillt this highly specialized press with a slide table to measure force and accuracy for a first tier automotive supplier.

Pressure settings are selected electronically through a GE 9030 programmable controller. The operator interface is mounted on a swing arm for the operator.

The press capabilities includes a range of force from 1,000 to 300,000 pounds, the press accuracy is able to be measured between 33,900 pounds to 300,000 pounds. Measurements are taken at low, medium and high forces.

Additionally the press measured position reversal accuracy of .050″+/.015″ and force reversal accuracy of +/- 1,000 pounds at low, medium and high forces.

Mechanically the press was machined so that the ram platen wear platen and table surfaces are flat within .002″ per foot. The ram wear platen and table surfaces are parallel within .015″ under full force load centered within 2″ of the centerline.

column press with hydraulic slide table

100 Ton Mobile Track Assembly Press We designed a 100 Ton Mobile Track Assembly Press for Volvo.

The press is designed so that the operator aligns the ends of the track by driving a guide pin into the holes, aligning the track ends. The operator then places a master pin into the guide hole.

The operator then aligns the C-Frame over the track. The C-Frame is suspended from a mobile crane which moves the press through the production line. Once the press is aligned, the operator uses a control valve to push the master pin and eject the alignment pin by the power supplied by the power unit. The power unit is connected to the press by a 20 foot long hose.

The press can be used for a number of assembly applications including pressing pins, bushings, and gears. The press can by laid on its back for stationary operations and is available in a number of different tonnages.

100 Ton Mobile Track Assembly Press

4 Ton Assembly Press

Application: Press a nylon hub with an OD of 7.5″ tube with an outside diameter of 6.7″
Press Specs: 4 ton horizontal press with tool plate supported by V grooved roller. Press also has a fixed bloster to the right side of the moving tool plate.
This customer is located in Edmonton, Canada.

Complete press specifications are available upon request.

VIEW OUR EXAMPLE ASSEMBLY PRESS GALLERY!
4 Ton Assembly Press